CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   Multidody Mesh (

fher1608 June 21, 2011 11:00

Multidody Mesh
Hi, I'm trying to study the aerodynamics of a wing, and for that I have created a mesh made of 4 zones (this is because I want a very precise control of the mesh). Once the mesh is done and with high quality I entered it in fluent.
The problem is that once in, the contact walls between the 4 bodies are recognized as walls and not as fluid. I don't know how to change this and I need some help. Any idea?? Thank you very much

William D Acosta June 22, 2011 11:13

hope that helps...

fher1608 June 29, 2011 12:33

The thing is that I'm using a sweep method mesh, and before doing that there were 4 sewpable bodies, and after doing that just one.

William D Acosta June 29, 2011 12:50

ok, if you have only 4 bodies and is not an annoyance to connect the faces manually, you can connect adjacent faces using a mesh interface instead of a multibody part.

See "Using non-conformal mesh" tutorial (Fluent help) for more info

fher1608 July 2, 2011 05:23

I tried creating a part from the 4 volumes and also I named the hole stuff. The thing is that, before doing this, there were 4 sweepable volumes, and before doing it there was only one, so I couldn't mesh the geometry as I wanted. How can I avoid this from happening?

All times are GMT -4. The time now is 07:23.