Weird problem in Mechanical APDL. Please give ur comments
Hi.
I am doing a simple heat transfer simulation in ANSYS Mechanical APDL. Normally under 'General postproc' there is "plot results" [under that "contour plot" and then "nodal solution"] But when i simulate my problem, which is a simple steady state heat transfer between two rectangles one inside the other, THE "plot results" just vanishes. Can any1 please tell me what could be wrong? I can give further explanation/ or diagrams if it is not very clear.. |
All times are GMT -4. The time now is 06:13. |