 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2011, 11:41
|
Slug flow boundary condition
|
#1 |
|
New Member
Dave Wang
Join Date: Oct 2011
Posts: 1
Rep Power: 0  |
Hi there,
I have some questions about boundary condition set-up for slug flow simulation using Fluent VOF model: How to set up inlet boundary condition when simulating slug flow in a horizontal pipe? Do I need to physically insert a split plane to separate the interface at the inlet? fine meshing for the split interface area? top for gas inlet and bottom for liquid inlet? Kind regards, |
|
|
|
|
 |
| Tags |
| inlet, slug flow, vof |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Boundary condition for exhaut flow with imposed mass flow | stephane | FLUENT | 1 | November 24, 2011 02:04 |
| Volume of Flow Rate (VFR) boundary condition | therockyy | FLOW-3D | 0 | May 23, 2011 14:19 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| How can apply mass flow rate boundary condition? | Sima | Phoenics | 1 | December 1, 2007 18:55 |
Linear Mode
