Measure lift and drag forces in 3D

henna07 · October 10, 2011, 16:01

Hi all

I am simulating airflow around a 50 mm square cylinder in a wind tunnel. In a 2D simulation it is very easy to get the lift and drag coefficients but I need to do a 3D analysis as well. The main point of the 3D analysis is to measure the lift and drag coefficients at different points along the span of the cylinder. Does anyone have any suggestions?

Thanks!

ExtraTim · October 17, 2011, 16:18

Assuming you are using FLUENT, I know you can break up a surface into separate surfaces and find the individual values that you are looking for, for each surface. I know in ICEM this is very simple, as you name your surfaces as you go, and I would assume doing it within any other modeling program would be just as easy.

Just make sure in FLUENT that you go under Monitors-->and specifically select an an individual drag/lift coefficient for each surface, rather than the entire part as a whole (which is what most people do, but I understand your problem is different). Just make sure your coefficients are pointing in the correct x/y/z directions and you should be good to go.

Best of luck!

October 10, 2011, 16:01	Measure lift and drag forces in 3D	#1
henna07 New Member Henna du Plessis Join Date: Oct 2011 Posts: 1 Rep Power: 0	Hi all I am simulating airflow around a 50 mm square cylinder in a wind tunnel. In a 2D simulation it is very easy to get the lift and drag coefficients but I need to do a 3D analysis as well. The main point of the 3D analysis is to measure the lift and drag coefficients at different points along the span of the cylinder. Does anyone have any suggestions? Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Drag and lift forces	fletcher	Main CFD Forum	5	September 5, 2011 13:03
using forces for geting drag and lift force magnitude?	510_	Main CFD Forum	2	October 28, 2010 11:42
Trying to calculate lift and drag forces	vkrastev	OpenFOAM	0	January 27, 2010 11:33
Lift & Drag forces from Transient Analysis	Richard	CFX	1	December 4, 2008 17:40
Lift and Drag Forces around an Aerofoil	studentcfd	CFX	1	October 29, 2007 17:36

October 17, 2011, 16:18		#2
ExtraTim New Member Tim Join Date: Jun 2011 Posts: 4 Rep Power: 14	Assuming you are using FLUENT, I know you can break up a surface into separate surfaces and find the individual values that you are looking for, for each surface. I know in ICEM this is very simple, as you name your surfaces as you go, and I would assume doing it within any other modeling program would be just as easy. Just make sure in FLUENT that you go under Monitors-->and specifically select an an individual drag/lift coefficient for each surface, rather than the entire part as a whole (which is what most people do, but I understand your problem is different). Just make sure your coefficients are pointing in the correct x/y/z directions and you should be good to go. Best of luck!