|
[Sponsors] |
November 5, 2011, 02:13 |
Draw a backward facing step microfluidic
|
#1 |
New Member
Join Date: Nov 2011
Posts: 24
Rep Power: 14 |
I'm new to ANSYS, and found hard time drawing figure above. I just managed to draw a rectangular box using extrude, however I found it hard to either trim the bottom part or create second part to merge it due to there's no selection point for it. The selection point is located at origin which is also at outlet, while I need to select point the is at the inlet. Any help is greatly appreciated. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |