|
[Sponsors] |
December 14, 2011, 12:40 |
i have a problem??
|
#1 |
New Member
cenk
Join Date: Dec 2011
Posts: 1
Rep Power: 0 |
hi guys.. i have a problem..
i'm meshing the pipe but end of the mesh ansys say "The default defeaturing was larger than one computed based on size control.The mesher has modified the global defeaturing tolerance accordinqly what is that? how am i solve this problem...Thank u.. |
|
December 15, 2011, 04:42 |
no problem
|
#2 |
Member
|
it is only warning not an error. so don't worry.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |