|December 22, 2011, 09:18||
Centrifugal Pump analyses Help
Join Date: Dec 2011
Posts: 1Rep Power: 0
For my design project I need to make cfd analyses for a centrifugal water pump.
I'm using Ansys 13 and Siemens Nx 7.5
I go over an Ansys 12 tutorial and I stuck due to a mismatch between two versions.
Problem 1 is I don't know which wall should I choose as interface side
Second problem is I don't know how to write an expression on post possessing part
I have only limited time and I'm open to all advice that you share..
Thanks in advance
Last edited by wyldckat; September 3, 2015 at 17:27. Reason: disabled embedded images
|December 22, 2011, 14:08||
Join Date: May 2011
Posts: 109Rep Power: 6
do u use MRF or Sliding mesh?
in MRF you dont have to make interface surfaces. choose interior as BC.
|Thread||Thread Starter||Forum||Replies||Last Post|
|release of the ERCOFTAC centrifugal pump - Fourth OpenFOAM Workshop||olivier||OpenFOAM||6||October 6, 2015 04:48|
|Autoblade centrifugal pump template||mahdi balali||NUMECA||3||February 18, 2014 09:56|
|Centrifugal Pump Cavitation problem or not.||ismael.s||CFX||13||February 27, 2012 09:00|
|Centrifugal Pump and Turbulence Model||Michiel||CFX||12||January 25, 2010 04:20|
|stator-rotor interaction in the centrifugal pump||G.H.Lee||Main CFD Forum||4||May 25, 1999 07:33|