CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   Opening geometry from Inventor (http://www.cfd-online.com/Forums/ansys/97452-opening-geometry-inventor.html)

Cipherflak February 17, 2012 07:42

Opening geometry from Inventor
 
I'm sure Ansys should be able to handle geometry made in Autodesk Inventor. But upon trying to load the Inventor geometry, I get a message that its an unsupported or unconfigured filetype. Any ideas how to fix/"configure" this?

Thanks a lot :)


All times are GMT -4. The time now is 22:02.