 |
 |
 |
|
|
|
[Sponsors] | ||||
October 21, 2012, 15:42
|
mass
|
#1 |
|
New Member
amin faghihi
Join Date: Oct 2012
Posts: 6
Rep Power: 13  |
Hi dear friends
I am modeling a cylinder in ignition mode with AKTIM under 1.46 bar pressure and 350 K temperature and .0004 m^3 as volume but after ignition pressure does not increase to maximum level of common pressure(45-50) bar. I explored the 2D result and I found that the total mass is about .0004 Kg that such a very little one.why?what can i do? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow inlet and pressure outlet with target mass flow rate | Zigainer | FLUENT | 13 | October 26, 2018 05:58 |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| mass does not conserve in Openfoam | conceptone | OpenFOAM | 5 | February 8, 2013 03:35 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Problem setting with chtmultiregionFoam | Antonin | OpenFOAM | 10 | April 24, 2012 09:50 |
Linear Mode
