Simulation of syngas-diesel dual fuel combustion with AVL FIRE

bahaaddein · October 2, 2012, 14:19

Hi and very good day every body
I would like to use AVL Fire as the tool to simulate the syngas-diesel dual fuel combustion operation, but I have not used AVL fire software before and I don't have any background about it. I have very limited time to do so, therefore I would be very grateful if you could help me by providing the best procedures to do so within very short time starting from creating the geometry.
Thank you

santoso_lipi · January 28, 2013, 06:19

You can define the syngas equivalence ratio in the Initial Condition and diesel fuel in Spray Module. The Combustion model could be selected as Eddy Break Up or ECFM combined with Diesel Ignited Gas Engine ignition model. Hopefully it may help

October 2, 2012, 14:19	Simulation of syngas-diesel dual fuel combustion with AVL FIRE	#1
bahaaddein New Member Bahaaddein Join Date: Sep 2012 Location: Malaysia Posts: 1 Rep Power: 0	Hi and very good day every body I would like to use AVL Fire as the tool to simulate the syngas-diesel dual fuel combustion operation, but I have not used AVL fire software before and I don't have any background about it. I have very limited time to do so, therefore I would be very grateful if you could help me by providing the best procedures to do so within very short time starting from creating the geometry. Thank you

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AVL Fire transonic simulation	Ainil	Main CFD Forum	1	August 24, 2010 15:53
WAVE Ricardo Software	CED	Main CFD Forum	42	March 26, 2010 03:57
NEED HELP on IC engine simulation with AVL FIRE!	Mohsen khalafi	Main CFD Forum	1	August 13, 2008 07:54
AVL fire CI engine simulation neeed HELP !	Mohsen khalafi	Main CFD Forum	0	March 24, 2008 16:15
Fire simulation using FDS from NIST	Jens	Main CFD Forum	1	January 22, 2004 01:53

January 28, 2013, 06:19		#2
santoso_lipi New Member Widodo Budi Santoso Join Date: Jan 2013 Location: Bandung, Indonesia Posts: 5 Rep Power: 2	You can define the syngas equivalence ratio in the Initial Condition and diesel fuel in Spray Module. The Combustion model could be selected as Eddy Break Up or ECFM combined with Diesel Ignited Gas Engine ignition model. Hopefully it may help