how to couple avl fire outputs to abaqus

mechanical · September 9, 2012, 04:23

Hi everyone, I want to couple avl fire to abaqus, I got heat transfer coefficient in avl results and now I want to import HTC data's to abaqus to get residual stress, Does any one know how can I do that?

regards

avlcfd · September 14, 2012, 07:40

Hi, you need to do the following:
a) project / map the FIRE output data to the ABAQUS grid (usually the two grids (fluid domain / structure domain) do not have conform interfaces
b) use the maed data and create an ABAQUS input deck

AVL FIRE Users often use FIRE user functions to do this.

Regards

mechanical · September 30, 2012, 08:57

thanks dear

but should I import both solid and fluid domain or Can I import solid domain only?
if I use a simple translation in modify mesh tab so both meshes in fire and abaqus match together well, so does it need transfer matrices anymore?

at last how can I use these data's to abaqus?

September 9, 2012, 04:23	how to couple avl fire outputs to abaqus	#1
mechanical New Member hhjj Join Date: Feb 2012 Posts: 8 Rep Power: 14	Hi everyone, I want to couple avl fire to abaqus, I got heat transfer coefficient in avl results and now I want to import HTC data's to abaqus to get residual stress, Does any one know how can I do that? regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing units in AVL Fire	zaer	AVL FIRE	2	July 18, 2012 00:27
New AVL FIRE Forum Opened	pete	Site News & Announcements	0	July 5, 2012 10:19
AVL Fire transonic simulation	Ainil	Main CFD Forum	1	August 24, 2010 15:53
AVL fire Exhaust manifold Simulation	mohsenfjs	Main CFD Forum	0	May 15, 2010 11:51
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

September 14, 2012, 07:40		#2
avlcfd New Member Maik SUFFA Join Date: Jul 2012 Posts: 7 Rep Power: 13	Hi, you need to do the following: a) project / map the FIRE output data to the ABAQUS grid (usually the two grids (fluid domain / structure domain) do not have conform interfaces b) use the maed data and create an ABAQUS input deck AVL FIRE Users often use FIRE user functions to do this. Regards

September 30, 2012, 08:57		#3
mechanical New Member hhjj Join Date: Feb 2012 Posts: 8 Rep Power: 14	thanks dear but should I import both solid and fluid domain or Can I import solid domain only? if I use a simple translation in modify mesh tab so both meshes in fire and abaqus match together well, so does it need transfer matrices anymore? at last how can I use these data's to abaqus?