Home > Forums > AVL FIRE

mass

Mark Forums Read

Reply

October 21, 2012, 15:42	mass	#1
aminfaghihi New Member amin faghihi Join Date: Oct 2012 Posts: 4 Rep Power: 2	Hi dear friends I am modeling a cylinder in ignition mode with AKTIM under 1.46 bar pressure and 350 K temperature and .0004 m^3 as volume but after ignition pressure does not increase to maximum level of common pressure(45-50) bar. I explored the 2D result and I found that the total mass is about .0004 Kg that such a very little one.why?what can i do?

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass does not conserve in Openfoam	conceptone	OpenFOAM	5	February 8, 2013 03:35
mass flow inlet and pressure outlet with target mass flow rate	Zigainer	FLUENT	10	January 5, 2013 21:51
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Problem setting with chtmultiregionFoam	Antonin	OpenFOAM	10	April 24, 2012 09:50
mass flow in is not equal to mass flow out	saii	CFX	2	September 18, 2009 08:07

All times are GMT -4. The time now is 18:56.