solver stopped output while copying arrays after rezone procedure
i am doing a simulation of the charge exchange for a combustion engine with fire version 2011.1 using a moving mesh built with fame engine plus. the mesh quality is supposed to be ok.
during the rezone procedure, the solver stopped its output. the cpu is still active. the last message of the .fla-file was: "start copying arrays".
i chect my harddisk memory and RAM, but none of them was critical.
did anybody have the same problem yet or does anybody have an idea how to carry on?
sorry, my fault: i havn't seen the (partially) negative volumes in my mesh...
finally it works
|All times are GMT -4. The time now is 08:21.|