|
[Sponsors] |
solver stopped output while copying arrays after rezone procedure |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 24, 2013, 03:46 |
solver stopped output while copying arrays after rezone procedure
|
#1 |
New Member
Join Date: Oct 2012
Posts: 11
Rep Power: 13 |
hi!
i am doing a simulation of the charge exchange for a combustion engine with fire version 2011.1 using a moving mesh built with fame engine plus. the mesh quality is supposed to be ok. during the rezone procedure, the solver stopped its output. the cpu is still active. the last message of the .fla-file was: "start copying arrays". i chect my harddisk memory and RAM, but none of them was critical. did anybody have the same problem yet or does anybody have an idea how to carry on? greetings |
|
March 26, 2013, 10:22 |
|
#2 |
New Member
Join Date: Oct 2012
Posts: 11
Rep Power: 13 |
sorry, my fault: i havn't seen the (partially) negative volumes in my mesh...
finally it works |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM export mesh | Youen | ANSYS Meshing & Geometry | 34 | April 23, 2017 12:15 |
thobois class engineTopoChangerMesh error | Peter_600 | OpenFOAM | 4 | August 2, 2014 09:52 |
Working directory via command line | Luiz | CFX | 4 | March 6, 2011 20:02 |
why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 14:08 |
compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 1, 2003 23:32 |