CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   AVL FIRE (http://www.cfd-online.com/Forums/avl-fire/)
-   -   batch job (http://www.cfd-online.com/Forums/avl-fire/126670-batch-job.html)

shahrbanoo November 22, 2013 18:30

batch job
 
Hi
I,ve started meshing with Fame engine pluse with single processor. but it takes a long time to be finished. how can I stop meshing?(of course I did it, but the crank angles that where had been meshing, were not meshed after again starting a new mesh) and start a new one with batch job?
I did all of this but batch job doesn' work and it's meshing with a single processor.

amin_u50 November 23, 2013 07:04

Hi...
Why? If you stop FEP your system finishes the meshing process. You can delete a file ;that I don not know its name exactly; in the mesh folder and start a new meshing. moreover, I think V.2008 is not able to use 2 cores at the same time but V.2011 can.
best regards SH.SH
amin -u50

shahrbanoo November 23, 2013 14:37

Hi
thanks dear amin_u50 for u'r answer
so I have to install Fire 2011 in near future!!
I have another problem now: :confused:
In the meshing process, I stopped meshing for changing the mesh setting and convert single processor to batch job, but I didn't succeed and the interval(i.g 475-485) had not been meshed and the intervals after that had been meshed. now I have 10CA that is not meshed! what should I do for meshing it?

shahrbanoo November 24, 2013 08:18

I found how to do it!
so simple!!

amin_u50 November 24, 2013 12:02

congratulation :)

mehi December 15, 2013 13:08

hi guys!
im recently working by fame engin plus.any body knows in fame engin plus at input surface section what is the range of cranck angle(valid from... to... cranck angle)?


All times are GMT -4. The time now is 20:04.