|December 22, 2013, 03:10||
Join Date: Mar 2013
Posts: 58Rep Power: 4
I want to see temperature contours in a SI Engine. I calculated it from CA 360 to CA 869. and it contains combustion.
when I want to see contours, I use impress cuts and I load the calculation in 860 CA. I expect to see only cylinder that piston is near bottom dead center, but I see piston is at top dead center and inlet valve is open(exactly like 360 CA condition)!
what is the reason that I confront this problem?
Last edited by shahrbanoo; December 22, 2013 at 04:31.
|Thread||Thread Starter||Forum||Replies||Last Post|
|"Pressure Inlet" Boundary Setup||Wijaya||FLUENT||14||August 26, 2015 06:02|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|problem in pressure gradient plot||kmgraju||CFX||1||March 10, 2013 17:52|
|Pressure BC for combustion chamber||Giuki||FLUENT||1||July 19, 2011 11:35|
|Plot pressure distribution on a section of 3d blade||Dr.been||FLUENT||1||July 8, 2010 10:05|