|
[Sponsors] |
May 13, 2014, 04:24 |
injector position error
|
#1 |
Member
shahrbanoo
Join Date: Mar 2013
Posts: 63
Rep Power: 13 |
Hi dears
I'm modeling SIDI engine.when after I run the case, it stops in the begining of spray start.and I face this error i fla file: Testing proper position of injector: %fire-I-cysetup, ========================================= %fire-I-cysetup, Bores could not be located inside domain. Check position of injector !!! %fire-I-cysetup, Test of injector position failed !!! Bore center at gridline or outside grid !!! %fire-I-cysetup, Calculation continues. ==================================== %fire-F-cyintro, Execution terminated! Bore seems partly outside domain. Tried more than 1000 times to locate parcel in bore. but I've checked and my injection place is in the computational domain. Actually my injection place is the same as injection direction in geometry data of Nozzle. Could u please help me? what is the problem? thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |