injection modeling -- CFD Online Discussion Forums

May 21, 2015, 09:59	injection modeling	#1
Fluent learner Member Join Date: Aug 2014 Posts: 31 Rep Power: 11	Hi I wanna to simulate injection in avl-fire.... I set all setting but when I define table for injection rate, half cone diameter and particle sizes....and press "start calculation" calculation finishes instantly and i dont get result but when I define constant number the program simulate spray anyone know how should i do? "Spray>>modules>>Particle introduction methods>>nozzles>>diagram>>injection rate, half cone diameter and particle sizes" thanks

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to go about modeling injection nozzle two phase flow in FLUENT?	skonda2	Fluent Multiphase	0	March 17, 2015 07:52
injection problem	Mark New	FLUENT	0	August 4, 2013 01:30
modeling de-moisturization of a plaster mould by air injection in CFX	sakalido	CFX	6	February 16, 2012 18:19
Modeling plastic injection process in CFX.	psicosis_x	CFX	2	April 13, 2011 14:04
modeling injection	abel	FLUENT	0	May 7, 2005 04:06

All times are GMT -4. The time now is 00:36.