CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Entries for December 2012

Register Blogs Members List Search Today's Posts Mark Forums Read

Old

Hexadominant method...

Posted December 20, 2012 at 11:42 by diamondx

I agree with "Far", but don't recommend the Hexadominant method for CFD.

The Hexadominant method starts by paving quads at the walls and then marches inward with isotropic hexas which can crash somewhat badly in the middle. This is good for FEA structural analysis where most of the interesting stuff happens near the surface and uniform elements are sufficient to capture it all, but it is not good for CFD.

However, if you tried Multizone (or sweep) with...
diamondx's Avatar
Super Moderator
Posted in Uncategorized
Views 1646 Comments 0 diamondx is offline Edit Tags
Old

Animation of Fluent transient data

Posted December 17, 2012 at 12:23 by diamondx

Actually CFD Post does support FLUENT transient files, but you should open a dat file that uses the FLUENT transient naming conventions, that is, filename-XXXXX.dat, where XXXXX is the timestep number. Your cas file should be named filename.cas (without the timestep number). If you have other cas files with the timestep number, try moving them to another folder.

I use it here a lot and it works fine.

Cheers.

By BRUNOC
diamondx's Avatar
Super Moderator
Posted in Uncategorized
Views 1703 Comments 0 diamondx is offline Edit Tags
Old

improving quality after merging tetra and prism

Posted December 1, 2012 at 10:19 by diamondx

you can only merge meshes if one side is all tetra... It needs the flexibility of the tetra mesh make it work. Prisms are too restrictive. We are working on ways to improve this situation.

Prism quality looks worse than it is... No worries there either.

As for the poor tetras, run the smoother with the prisms and hexas frozen... see what it can do. It should fix most tetras. The tetras it can't fix are those that are stuck between close layers of prisms... ...
diamondx's Avatar
Super Moderator
Posted in Uncategorized
Views 1805 Comments 1 diamondx is offline Edit Tags
Old
Rating: 4 votes, 5.00 average.

Best Mesh Generation Software

Posted December 1, 2012 at 07:59 by Far

Rule of thumb:

1. Use the mesh generator which is being used by your friends who are available to help you out.

2.Best sotware in market is ICEM (Hexa), but it is difficult to learn and takes alot time in mastering. Its tetra + prism version is very efficient and easy to use.

3. Ansys meshing is new technology and very easy to use.

4. Gambit is very easy to learn and its tetra with boundary layer (in 3d implementing boundary layer often...
Far
Super Moderator
Posted in Uncategorized
Views 46150 Comments 15 Far is offline Edit Tags

All times are GMT -4. The time now is 05:41.