The purpose of this blog is to promote the use of Open Foam as a candidate for Mold Flow analysis,
as well as to collaborate and share ideas with others in the injection moulding industry.
as well as to collaborate and share ideas with others in the injection moulding industry.
Open Foam for Mold Flow analysis
Posted March 20, 2010 at 10:12 by KyleL
Hello all and welcome to my blog.
It appears to me after going through most of the tutorials that Open Foam is the ideal candidate for an open source mold flow analysis tool.
Open Foam is a very powerful, robust C++ library for computational programming.I see no reason why Open Foam can not be just as popular as the bigger names,i.e. MOLDFLOW & FLOW-3Din injection moulding, and even easier to use.The best benefit would be the support of the open source community and our willingness to share code as well as improve on existing code without the need for monetary gain.
I am a relative newbie to Open Foam and definitely not a programmer. But that does not mean that I can not contribute to the testing and evaluation of any ideas, thoughts or processes
I look forward to working with any of you that might be interested in doing the same.
Kyle L.
It appears to me after going through most of the tutorials that Open Foam is the ideal candidate for an open source mold flow analysis tool.
Open Foam is a very powerful, robust C++ library for computational programming.I see no reason why Open Foam can not be just as popular as the bigger names,i.e. MOLDFLOW & FLOW-3Din injection moulding, and even easier to use.The best benefit would be the support of the open source community and our willingness to share code as well as improve on existing code without the need for monetary gain.
I am a relative newbie to Open Foam and definitely not a programmer. But that does not mean that I can not contribute to the testing and evaluation of any ideas, thoughts or processes
I look forward to working with any of you that might be interested in doing the same.
Kyle L.
Total Comments 2
Comments
-
Hi, is this project sill alive?Posted June 2, 2014 at 06:50 by Pisolino
-
I am interested in this project too if anyone out there is looking for a teamPosted November 19, 2014 at 18:14 by pawanhv
