|April 28, 2012, 00:46||
Solution isn't converging!
Join Date: Jun 2011
Location: Blacksburg, Virginia
Posts: 29Rep Power: 7
I am carrying out an analysis of flow over a half wing. I am doing it for different aspect ratios. However, what is happening is that when I use a particular set of settings for the mesh for cases with higher aspect ratio, I am getting a converged solution, but when I reduce the aspect ratio of the wing, the solution diverges.
Why could this be happening? I reduced the mesh size as well but that is not working. Otherwise modelling of the physics is to remain the same, right?
Thanks in advance,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Trying to perform test validity of Fluent with simulation of 2D airfoil||didiean||FLUENT||39||December 5, 2015 14:31|
|Solution not converging||Alex||FLUENT||5||April 14, 2015 00:55|
|interFoam solution tolerances||mgdenno||OpenFOAM||4||September 13, 2011 12:58|
|Unsteady solution||Christophe||FLUENT||0||August 11, 2006 11:13|
|Discussion about Mesh independant solution||Seb||Main CFD Forum||13||May 22, 2001 13:37|