|January 15, 2013, 16:12||
Deformable mesh or not,
Join Date: Jan 2013
Posts: 1Rep Power: 0
I am really new in the CFD, expecially with STAR CCM, so my question could be stupid but I could not get this information.
I made a simulation of a floating body, with the model VOF WAVE, so my problem is:
How can I know if the mesh that I am using is deformable during the motion of the floater?
I use a continuum mesh>model>trimmer,surfer remesher and prism layer mesher, togheter with an anisotropic volume control around the free surface.
Any help would be really appreciated
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||40||January 20, 2016 01:08|
|how to set periodic boundary conditions||Ganesh||FLUENT||13||January 22, 2014 05:11|
|Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre||powpow||CFX||3||December 20, 2012 10:14|
|Add Mesh Layers doesnt work on the whole surface||Kryo||OpenFOAM Native Meshers: snappyHexMesh and Others||8||September 13, 2012 09:28|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|