 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2013, 13:32
|
Volumetric control
|
#1 |
|
Member
Arun Krishnan.L.H
Join Date: Jan 2013
Posts: 75
Rep Power: 13  |
Hi all,
I am new to STAR CCM+ and trying out simple problems to work with the software. I had tried to simulate flow past a cylinder in a fluid domain. For mesh models i had used surface remesher, prism layer and trimmer. I got good results when compared to ref papers. I tried to change the meshing and use polyhedral but now the volumetric control does not work. I have tried to change the values but still unsuccessful. Can anyone please tell me why i am not able to generate volumetric control in polyhedral. I have done everything as the manual says. Please advice if you know. Regards Arun Last edited by arun7328; February 23, 2013 at 13:52. Reason: delete |
|
|
|
|
|
February 23, 2013, 13:52
|
|
#2 |
|
Member
Arun Krishnan.L.H
Join Date: Jan 2013
Posts: 75
Rep Power: 13 |
hi all..
sorry for the post..I have found the answer. Thanks |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems of running Oscillating plate tutorial | vovogoal | CFX | 20 | February 4, 2016 07:03 |
| FSI: Pressure and Normal Force don't match with expected values | Geraud | CFX | 6 | August 21, 2012 15:34 |
| Match Control and Symmetry Boundary Condtions in a quasi 2D calculation | peterputer | ANSYS Meshing & Geometry | 0 | May 15, 2012 08:53 |
| volumetric control total cell count | sieginc. | STAR-CCM+ | 12 | November 14, 2011 16:49 |
| Volumetric Control Problem | boathead | STAR-CCM+ | 5 | April 1, 2011 13:46 |
Linear Mode
