|September 15, 2015, 11:07||
Adding Radiation Heat Flux to 2D simulation in Starccm+
Join Date: Jun 2014
Posts: 5Rep Power: 4
I am designing a building in front of a flow of atmospheric air around it. I wanted to model the sun's heat flux in 2D, but there seems to be no way to do it without the solar loads calculator, which is not available in the Participating Media model. The S2S model is not applicable in 2D.
I have tried to set a user defined wall heat flux cond A, leaving B,C,D zero and setting emissivity to one, environmental condition with zero heat transfer co-efficient.
Would really, really appreciate an answer, it's such a big headache.
|heat flux, radiation, starccm|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Udf for moving heat flux in 2D cylindrical geometry||devia21||Fluent UDF and Scheme Programming||0||April 20, 2015 00:27|
|Viewfactors - specified fixed radiation wall heat flux||kuczmas||OpenFOAM Running, Solving & CFD||1||June 12, 2014 07:27|
|Adding heat flux and pressure at free surface||tyb001||FLUENT||0||January 31, 2013 11:13|
|Heat Flux Profile at Fluid-Porous Interface||Hitch8||CFX||4||December 15, 2012 10:57|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|