CFD Online Logo CFD Online URL
Home > Forums > CD-adapco

patch on a pie section

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   July 18, 2000, 00:19
Default patch on a pie section
Posts: n/a

I have started using StarCD, and have run through the tutorials, however on a current individual problem I do not seem to find an answer, thus seeking help.

I have a section of fluid which is a section of a circle (a bit like the shape of a piece of cake or pie). However the the radius is not constant. On trying to make the grid I have used vertices with a spline, hoping to extrude this latter on. My problem is that the patch command is unable to use just 3 vertices (one being the center, and the two corner edges connecting the spline). I have experimented with combinations, and searched for alternatives to no benefit.

I understand this is not cutting edge, but I have had no success elsewhere.
  Reply With Quote

Old   July 18, 2000, 07:21
Default solved it!
Posts: n/a
the problem was able to be solved by treating the centre of the pie shape as points 1 and 2 in the patch command.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
HELP NEEDED HOW TO MAP VALUES FROM PATCH OF ONE MESH TO PATCH OF ANOTHER MESH mkraposhin OpenFOAM Running, Solving & CFD 3 September 4, 2011 09:42
Cross-Section sidd CD-adapco 2 March 10, 2008 05:14
Turbulence Section Jonas Larsson CFD-Wiki 7 June 20, 2007 03:42
New Section Ynot (previously jedi) CFD-Wiki 3 December 5, 2005 07:36
Exporting just a section Mahdi FLUENT 1 May 7, 2005 19:51

All times are GMT -4. The time now is 01:24.