CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A (http://www.cfd-online.com/Forums/cd-adapco/52540-comands-export-gambit-mesh-prostar3100a.html)

Cerioni February 8, 2001 07:50

COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
I'd like to know the best exportation format file for Gambit and the correct comands to import it!

Chinor February 8, 2001 17:57

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
Read the Gambit neutral file or mesh file into Tgrid.

From Tgrid, write out a Patran file.

Import the Patran file into Prostar.

Chinor

Cerioni February 9, 2001 04:56

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
What's this "Tgrid" ,is it acomand of Gambit? Sorry for the stupid question but I'm a beginner! However thankyou Chinor

Chinor February 9, 2001 15:38

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
Tgrid is another pre-processor for Fluent.

You should check with your software custodian to see if you have this piece of software.

Chinor

hvn February 12, 2001 13:44

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
Save your gambit mesh in neutral and in star-cd, in the command line, type the command : gambit nameofyourmesh.neu

Chinor February 13, 2001 13:58

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
hvn

I tried that and Prostar (v3100a) crashed.

Did you actually do this successfully?

Chinor

Cerioni February 15, 2001 06:05

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
with 3100A cruched, with 3100 didn't cruch but it isn't successful!

hvn February 20, 2001 13:08

Re: COMANDS TO EXPORT GAMBIT MESH IN PROSTAR3100A
 
I used this command with prostar v3100 and there was no problem. The mesh in prostar was identically as in fluent 5 and in Gambit


All times are GMT -4. The time now is 02:22.