CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CD-adapco

making a case all aver again

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   September 21, 2001, 11:34
Default making a case all aver again
  #1
Ossi
Guest
 
Posts: n/a
Hello, I have an existing transient case in Prostar. Now, I would like to make a new case but use the same mesh and boundary conditions because the existing case is corrupted (it can be read into Prostar without error messages). So, is it possible to delete everything else except the mesh ? Or do I have to make the case all aver again ?
  Reply With Quote

Old   September 21, 2001, 12:00
Default Re: making a case all aver again
  #2
steve
Guest
 
Posts: n/a
After you read in the model, use cwrite, vwrite and bwrite to write out cells, vertices and boundaries. Then start a new prostar and use cread, vread and bread to get all this data back in.
  Reply With Quote

Old   September 21, 2001, 14:53
Default Re: making a case all over again
  #3
Ossi
Guest
 
Posts: n/a
Thanks for the information ! Although I could not get the cell table information (cell type, color etc.) back to the new case as well as I could not get the boundary information back ?
  Reply With Quote

Old   September 22, 2001, 07:13
Default Re: making a case all over again
  #4
Joern Beilke
Guest
 
Posts: n/a
You could have used "cdsave" instead of of c/v/bwrite. Then you also get an case.inp file with all the settings. There you can delete all the stuff you don't want and do an "ifile ..."

  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Cloning a case or creating a new case for 16 processes mellanoxuser OpenFOAM Running, Solving & CFD 0 February 8, 2008 16:52
Please help with making links Michail CFD-Wiki 3 October 15, 2005 17:35
making MPEG Andrej CFX 0 October 3, 2002 08:35
MaKing Graphs july CD-adapco 0 February 13, 2002 03:36
about making makefile JunseokKim Main CFD Forum 1 May 16, 2001 21:39


All times are GMT -4. The time now is 04:20.