CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CD-adapco

mrf

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   March 1, 2002, 08:24
Default mrf
  #1
Lorenzo Arcangeli
Guest
 
Posts: n/a
When using mrf explicit, which values I must assign to coupled boundary inlet-pressure at the interface to obtain a correct solution ?

Lorenzo Arcangeli
  Reply With Quote

Old   March 2, 2002, 12:41
Default Re: mrf
  #2
ccy
Guest
 
Posts: n/a
you can use boundary couple command. The default tolerence should work well.
  Reply With Quote

Old   March 3, 2002, 06:56
Default Re: mrf
  #3
LORENZO ARCANGELI
Guest
 
Posts: n/a
I used region couple command, but I don't know which values to assign to coupled boundaries. I tried to assign 0 to both inlet and pressure, but it seems not to be mass flux between the static and rotating region,and the pressure field is not continuos.

Thank you for helping me,

Lorenzo
  Reply With Quote

Old   March 4, 2002, 06:04
Default Re: mrf
  #4
john
Guest
 
Posts: n/a
You have to assign some reasonable values to start the flow. For example, you have boundaries like this:

=>INLET ||Coupled => PRESSURE

pressure | Inlet

At coupled inlet, you can assign a velocity which will have same mass flow rate at INLET. And the coupled pressure, the pressure must be higher than outlet PRESSURE.

The values does not need to be exact since these will be updated as part of the solution, but must be "reasonable" for flow to start.

I hope it helps.
  Reply With Quote

Old   March 7, 2002, 06:37
Default Re: mrf
  #5
LORENZO
Guest
 
Posts: n/a
Thank you for your answer,but I have a doubt,I can fix the same mass flux at the coupled inlet only if I do an uncompressible run, because I know density....and if the calculation is compressible?

Thank you,

Lorenzo
  Reply With Quote

Old   March 8, 2002, 14:58
Default Re: mrf
  #6
john
Guest
 
Posts: n/a
It really does not matter: you are only giving approximate boundary conditions to start the flow: the real boundary condition will be obtained as part of the solution.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -4. The time now is 09:23.