|
[Sponsors] |
July 12, 2002, 08:29 |
How to put two models together
|
#1 |
Guest
Posts: n/a
|
I've two models. One is the inlet duct of a pump, the other is the inlet volume iside the pump.
So far, I've worked with the separetly: two models, two meshes, two simulation. How can I put them together in one mdl file? Geometries are very complex, so I cannot rebuild one of them in the other's mdl file. |
|
July 15, 2002, 06:03 |
Re: How to put two models together
|
#2 |
Guest
Posts: n/a
|
Just search a little bit in this forum. It was discussed some time ago. (cdsave, cwri, vwri, cpwri, cread, vread, cpread). Or use the databases in proam.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two-fluid models vs mixture models for bubbly flows | Hansong Tang | Main CFD Forum | 6 | December 8, 2009 03:21 |
MODELS | Murthy V N | FLUENT | 0 | February 9, 2008 01:48 |
LES models | fran | Main CFD Forum | 1 | August 25, 2005 06:44 |
MRF and DPM models | you | FLUENT | 0 | June 8, 2001 05:49 |
...models... | Dia Zeidan | Main CFD Forum | 2 | February 9, 2001 12:54 |