Total pressure to static pressure ratio

April 16, 2003, 10:05

Hi all. I have the following problem: flowbox of an engine manifold, Inlet BC stagnation, outlet BC pressure.Turbulent (ke) compressible flow. The reference pressure is 98000Pa, and the reference cell is on the pressure boundary. The total pressure is 2000Pa (relative). The calculations seems to run properly till convergence, but the output values of pressure are strange, and I have the warning message "ratio of total to static pressure (at stagnation boundary)less than 1..." The total pressure at inlet is 101432,static pressure at inlet is 101233. How can it be possible?

April 17, 2003, 05:31

Have you check the ratio of every cell in the inlet?

April 16, 2003, 10:05	Total pressure to static pressure ratio	#1
roadracer Guest Posts: n/a	Hi all. I have the following problem: flowbox of an engine manifold, Inlet BC stagnation, outlet BC pressure.Turbulent (ke) compressible flow. The reference pressure is 98000Pa, and the reference cell is on the pressure boundary. The total pressure is 2000Pa (relative). The calculations seems to run properly till convergence, but the output values of pressure are strange, and I have the warning message "ratio of total to static pressure (at stagnation boundary)less than 1..." The total pressure at inlet is 101432,static pressure at inlet is 101233. How can it be possible?

April 17, 2003, 05:31	Re: Total pressure to static pressure ratio	#2
Jing Guest Posts: n/a	Have you check the ratio of every cell in the inlet?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
static vs. total pressure	auf dem feld	FLUENT	17	February 26, 2016 13:04
total or static pressure?	George	Main CFD Forum	0	November 22, 2005 03:53
Static, Total pressure	DSS	Siemens	1	May 27, 2005 07:09
static or total pressure?	Tim	Phoenics	1	September 24, 2003 12:36
Static vs Total Pressure	Alfonso Ferrandez	FLUENT	2	May 23, 2000 08:53