CFD Online Logo CFD Online URL
Home > Forums > CD-adapco

internal combustion engine port flow simulation

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   April 28, 2003, 02:52
Default internal combustion engine port flow simulation
Posts: n/a
hi, everyone. If I do a 86*86, 16v, intake port diameter 30mm, how should I set the cell length and subsurface thickness? Thank you very much.
  Reply With Quote

Old   April 29, 2003, 03:48
Default Re: internal combustion engine port flow simulatio
Posts: n/a
Firstly - cell length Your minimum cell length will be decided by the scale of the smallest feature & curvature which you think is important to capture. For INtake POrt flows this will almost certainly be around the valve seat. Similarly, the minimum y+ values and hence minimum sub-surface thickness will be decided by the local velocitys around the valve seat region. You can make an estimate of this 'a priori' to running the case, using 1D theory, the lift gap area and an estimate of Cd=0.7. For your case i would expect to use minimum cell length circa 0.25mm around the valve seat and upwards of 0.25mm near wall cell thickness. Note: Wall functions fo this type of analysis are rather unreliable but should give flowrate prediction circa +/-5%. If you get any closer then it is luck not physical model accuracy! ProAm will make an admirable attempt at trimming an Inlet port mesh, but it helps if you can create a Custom mesh first with Polar regions around the valve seats.
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
CFD simulation in Internal Combustion Engine Anne Main CFD Forum 19 June 29, 2015 03:23
Tutorial 13 Internal Combustion Engine Wei CD-adapco 11 March 6, 2009 07:24
Internal combustion engine Akuma FLUENT 0 January 30, 2007 07:02
Internal combustion engine Akuma FLUENT 0 January 30, 2007 03:58
numerical simulation of internal combustion engine hamed FLUENT 0 October 19, 2005 03:03

All times are GMT -4. The time now is 04:55.