Multi Phase option problem....

May 21, 2003, 12:52

Hi StarCD experts! I'm trying to run an analysis using the multi phase treatment on "Lagrangian Multi-phase". I have already solved my geometry (which is on Transient) and now I'm trying to put some Droplets.. When I restarting the analysis and I'm receiving a very "wierd" message:

" *** GEOMETRICAL CALCULATIONS STARTED *** GEOMETRICAL CALCULATIONS COMPLETED

*** ERROR #244 *** MULTI-PHASE OPTION CHOSEN: INADEQUATE PARAMETER NCMAXV or/and NCTMXC IN parm.inc "

I have already tried to correct the value in the prosize file with no luck... Can anyone suggest something?

May 22, 2003, 07:53

Could be a prostar bug or could be caused by your not writing geometry file after turning on droplet. The solution is very simple: just edit parm.inc and put NCMAXV = NCMAX, NBMAXV=NBMAX, NBTMXC=NBMAX, NCTMAXC=NCTMAX and use starlink again.

May 21, 2003, 12:52	Multi Phase option problem....	#1
Christos Sfyris Guest Posts: n/a	Hi StarCD experts! I'm trying to run an analysis using the multi phase treatment on "Lagrangian Multi-phase". I have already solved my geometry (which is on Transient) and now I'm trying to put some Droplets.. When I restarting the analysis and I'm receiving a very "wierd" message: " * GEOMETRICAL CALCULATIONS STARTED * GEOMETRICAL CALCULATIONS COMPLETED * ERROR #244 * MULTI-PHASE OPTION CHOSEN: INADEQUATE PARAMETER NCMAXV or/and NCTMXC IN parm.inc " I have already tried to correct the value in the prosize file with no luck... Can anyone suggest something?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem about multi-phase analysis (Urgent)	Prof. Lau (PolyU)	CFX	2	February 9, 2007 17:59
A strange problem when doing multi-phase flow	Yun Kang	CFX	0	September 28, 2006 09:26
Phase change with granular option.	MP	FLUENT	0	February 2, 2003 21:15
heat transfer problem in multi-phase flow	verypuzzled	CFX	1	October 3, 2001 11:16
Multi-phase	cehuang	FLUENT	2	October 1, 2001 15:25

May 22, 2003, 07:53	Re: Multi Phase option problem....	#2
John Guest Posts: n/a	Could be a prostar bug or could be caused by your not writing geometry file after turning on droplet. The solution is very simple: just edit parm.inc and put NCMAXV = NCMAX, NBMAXV=NBMAX, NBTMXC=NBMAX, NCTMAXC=NCTMAX and use starlink again.