Can this warning influence the results?

July 11, 2003, 04:57

when I finished running a model (the boundary in inflow region is a stagnation boundary, the boundary in outflow region are several pressure boundary),I found one warning message at the first some iterations: *** WARNING #061 *** RATIO OF STAGNATION PRESSURE AND STATIC PRESSURE AT REGION 1 CELL *** LESS THEN 1. TEMPORARILY SET TO 1.

And when I checked the solution,I doubted the results are correct,but I was not sure that.

So is there anyone who can tell me whether the above warning messages would influence the results?

Thanks a lot for your kind help!

Lee

July 11, 2003, 06:40

Since this message only appears at the start of your calculation (which is quite normal as the flow inside tries to adjust), it will definitely NOT affect your results.

July 11, 2003, 04:57	Can this warning influence the results?	#1
Lee Guest Posts: n/a	when I finished running a model (the boundary in inflow region is a stagnation boundary, the boundary in outflow region are several pressure boundary),I found one warning message at the first some iterations: * WARNING #061 * RATIO OF STAGNATION PRESSURE AND STATIC PRESSURE AT REGION 1 CELL *** LESS THEN 1. TEMPORARILY SET TO 1. And when I checked the solution,I doubted the results are correct,but I was not sure that. So is there anyone who can tell me whether the above warning messages would influence the results? Thanks a lot for your kind help! Lee

July 11, 2003, 06:40	Re: Can this warning influence the results?	#2
John L Guest Posts: n/a	Since this message only appears at the start of your calculation (which is quite normal as the flow inside tries to adjust), it will definitely NOT affect your results.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gravity (g) Influence on Simulation Results	Colin	FLUENT	12	September 23, 2015 09:45
Pressure influence	Fanny	Main CFD Forum	1	January 30, 2009 23:39
influence of yplus	Flo	Main CFD Forum	5	July 24, 2008 01:31
Influence of Y+ value	xiang	FLUENT	3	February 6, 2004 19:31
Gravity g's influence on Simulation Results	Colin	Main CFD Forum	6	November 2, 2003 14:13