How to get data I need from a converged flowfield?

September 18, 2003, 23:10

Dear All,

I need to get the viscous dissipation term: (shear stress*(partial u_i/partial x_j)) which appears in the energy equation. (See eq. (1-10) the Star-Cd ¡§Methodology¡¨ book p. 1-3) from a covergent flowfields. How should I do? Thanks for reply.

September 20, 2003, 09:22

You can do it either in PROSTAR or within the user subroutine POSDAT.F, whereas the most accurate answer will be obtained with the user subroutine. You have to declare a passive scalar in PROSTAR to will be used for storing the calculated value of the dissipation term. Using POSDAT.F, you calculate the term you need with the appropriate STAR subroutines for gradient calculation (ask your local support office to help you in this matter). Then dump the value calculated in the T array at the place reserved for the dummy scalar you had defined previously.

September 18, 2003, 23:10	How to get data I need from a converged flowfield?	#1
Ko Guest Posts: n/a	Dear All, I need to get the viscous dissipation term: (shear stress*(partial u_i/partial x_j)) which appears in the energy equation. (See eq. (1-10) the Star-Cd ¡§Methodology¡¨ book p. 1-3) from a covergent flowfields. How should I do? Thanks for reply.

September 20, 2003, 09:22	Re: How to get data I need from a converged flowfi	#2
4xF Guest Posts: n/a	You can do it either in PROSTAR or within the user subroutine POSDAT.F, whereas the most accurate answer will be obtained with the user subroutine. You have to declare a passive scalar in PROSTAR to will be used for storing the calculated value of the dissipation term. Using POSDAT.F, you calculate the term you need with the appropriate STAR subroutines for gradient calculation (ask your local support office to help you in this matter). Then dump the value calculated in the T array at the place reserved for the dummy scalar you had defined previously.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Flowfield initialization in OpenFOAM	ashishnedungadi	OpenFOAM Running, Solving & CFD	1	March 15, 2009 03:52
Flowfield initialization in OpenFOAM	ashishnedungadi	OpenFOAM Running, Solving & CFD	0	March 14, 2009 21:43
About flowfield-dependent variation(FDV) method?	Jinwon	Main CFD Forum	1	December 4, 2007 21:13
Froozen flowfield	Allan	Siemens	3	November 16, 2001 13:30
pressure in turbulence flowfield	Yu-Li Chang	Main CFD Forum	0	April 28, 2000 10:14