|April 15, 2004, 17:52||
Doubt with modeling!!
I had mailed in a couple of days back about a gas modeling for a container carrying drums consisting of gases. Suppose the gas leaks out of the drums, I need to find out at what rate the gases are leaking, or the concentration of the gas in different parts within the container.
I was planning to model the container with drums on ProStar, I have figured out how the container can be designed and how to select certain cells from it and monitor them. But I am not sure of how to go about designing the drums within them.
Could anybody please help me here by answering the following questions....
1. Is my idea and my method of dealing with the problem correct? 2. If it is, then how to desing the drums (within the container) and what equation should I be looking to solve to determine concentration?
Thanks, best regards, Arun.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Doubt||Rishikesh||FLUENT||0||February 24, 2009 04:32|
|Doubt||Fluent Learner||FLUENT||1||September 1, 2008 10:57|
|A doubt||Alberto Passalacqua (Alberto)||OpenFOAM Pre-Processing||5||November 28, 2006 10:22|
|doubt||chandu||FLUENT||2||August 23, 2005 05:17|
|Doubt||Mukund||FLUENT||4||August 4, 2004 11:28|