CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   Problems with ICEM 4.2.2 + STAR-CD (http://www.cfd-online.com/Forums/cd-adapco/53785-problems-icem-4-2-2-star-cd.html)

DIA May 6, 2004 12:49

Problems with ICEM 4.2.2 + STAR-CD
 
Hi, all.

I am begining in CFD. There are the module IC3M in ICEM and the tutorial "Diesel". I run ICEM. It completed work and write 'all OK', but when I implement all recomendation and try run STAR-CD - very many mistakes in geometry. I don't say about boundary and other. Only geometry.

What anybody think about it? Who had confronting this problem?

Birute May 10, 2004 12:11

Re: Problems with ICEM 4.2.2 + STAR-CD
 
Hello,

What kind of mistakes you get?

Bi.

Jean-Francois June 17, 2004 12:42

Re: Problems with ICEM 4.2.2 + STAR-CD
 
Personnaly I may get problems when merging meshes into Icem and load it in Star. This is partly solves in 4.3.3. that has been patched. But I recently had problem with merged meshes (tets + hexa) that I did not couple at the interfaces between the sub-meshes.

I am interested in other's experience, since I think that Icem is powerful but that problem is really painful.


All times are GMT -4. The time now is 05:30.