 |
 |
 |
|
|
|
[Sponsors] | ||||
November 10, 2004, 10:26
|
Proam:Poorly Formed Cells
|
#1 |
|
Guest
Posts: n/a
|
Hi,
Finally I got a mesh with only 17 Poorly Formed Cells...must I fix them or they usually don't affect the numerical solution (I'm using Comet for a steady state simulation)? How can I fix them? Using TetFix one by one? I hope not because I normally got 100 poorly formed cells! Thank you, Erika |
|
|
||
|
November 11, 2004, 01:43
|
Re: Proam:Poorly Formed Cells
|
#2 |
|
Guest
Posts: n/a
|
Hi,
very poorly formed cells may affect the convegance and it takes long time. If possible fix it using tetfix |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help proam | yogesh | Siemens | 8 | February 16, 2006 05:19 |
| proam | sankar | Siemens | 0 | February 23, 2005 04:58 |
| Proam cpmatches | Erika | Siemens | 3 | November 8, 2004 19:21 |
| Shell cells to Fluid cells | Mahbub | Siemens | 1 | October 20, 2003 15:21 |
| UDF: neighbour cells, upwind cells | Dmitriy Makarov | FLUENT | 0 | February 18, 2001 13:53 |
Linear Mode
