CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CD-adapco

Simple Divergence Problem

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   February 17, 2005, 11:45
Default Simple Divergence Problem
  #1
Cb
Guest
 
Posts: n/a
Hello everyone,

Im running what I think it a relatively simple simulation, but cannot get the solution to converge.

Its an inlet system for a car. A volume for the atmosphere leading to a bellmouth, through a restrictor, to a plenum and then 4 runners.

I ran the sim initially with 5 pressure boundaries on the volume, and a slip wall on the wall that the bellmouth was attached to. I had a pressure boundary at the base of one of the runners.

This ran ok, but then I realised it was in the wrong units. I changed to inches, put a pressure boundary instead of the slip wall and now the model will not converge. I changed a lot, but no matter what boundaries I have on it now it seems to diverge, residuals - DISS goes to Inf and ENTH goes to NaN.

Any suggestions?
  Reply With Quote

Old   February 17, 2005, 11:46
Default Correction
  #2
Cb
Guest
 
Posts: n/a
Sorry, DISS goes to NaN, ENTH goes to NaN and T EN goes to Inf, although sometimes the divergence is a combination of one or two of these, not necessarily all 3.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
AMG Divergence problem mkrao FLUENT 1 December 30, 2008 02:51
Divergence problem George CD-adapco 6 March 24, 2007 13:34
divergence problem vincent FLUENT 3 August 3, 2006 15:44
divergence problem Ayyappan.T FLUENT 2 May 16, 2005 12:10
divergence problem.. jieremy FLUENT 8 May 23, 2003 03:17


All times are GMT -4. The time now is 00:06.