Moving Mesh with NEWXYZ

March 20, 2005, 00:30

I'm using subroutine NEWXYZ.F to move mesh, but i could not set the correct moving event. how to do it?

thanks very much!

March 20, 2005, 22:49

Linking pmov executable...

FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE

*** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1

RELINK pmov AFTER UPDATING THE PARAMETER FILE

How to make it correct? thanks.

March 21, 2005, 02:45

I use the following codes in prostar:

time trans mvgrid on geom,XXX prob,XXX

then in terminal,

pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE

*** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1

RELINK pmov AFTER UPDATING THE PARAMETER FILE

HOW TO make it correct? thanks

March 20, 2005, 00:30	Moving Mesh with NEWXYZ	#1
Dorain Guest Posts: n/a	I'm using subroutine NEWXYZ.F to move mesh, but i could not set the correct moving event. how to do it? thanks very much!

March 20, 2005, 22:49	Re: Moving Mesh with NEWXYZ	#2
dorain Guest Posts: n/a	Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE * ERROR * MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE How to make it correct? thanks.

March 21, 2005, 02:45	Re: Moving Mesh with NEWXYZ	#3
dorain Guest Posts: n/a	I use the following codes in prostar: time trans mvgrid on geom,XXX prob,XXX then in terminal, pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE * ERROR * MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE HOW TO make it correct? thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving Reference frame - UDF - Moving mesh	modisa	FLUENT	0	April 18, 2008 13:31
Who has some samples about subroutine newxyz?	jshi	CD-adapco	3	May 9, 2006 20:29
How to get pressure value in 'NEWXYZ' subrutine	Henry Huang	CD-adapco	2	March 6, 2006 05:37
NEWXYZ	leo	CD-adapco	0	February 4, 2003 17:59
subroutine newxyz	leo	CD-adapco	3	October 3, 2002 06:24