CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   Fortran Compiler in Star-CD (http://www.cfd-online.com/Forums/cd-adapco/54519-fortran-compiler-star-cd.html)

Anne April 14, 2005 08:31

Fortran Compiler in Star-CD
 
Hi, guys,

Except for the Absoft Fortran Compiler, is there any other Fortran compiler that can be used to build the user subroutine in Star-CD? I have Compaq Fortran.

If so, how to set the enviroment variables?

Pauli April 14, 2005 09:58

Re: Fortran Compiler in Star-CD
 
Compiler requirements are platform specific. There is a table in the installation notes.

If you do not have access to the installation notes, please be a little specific.

My guess is that you are on 32bit Linux. If so, the answer is no, only Absoft is supported.

Anne April 14, 2005 13:47

Re: Fortran Compiler in Star-CD
 
Thanks first.

I have read the installation note carefully. It is said before Star-CD installation, Absoft ProFortran should be installed. I have no this complier. I am wondering if there are ny other alternatives.

Pauli April 14, 2005 15:01

Re: Fortran Compiler in Star-CD
 
This question has been covered before on this site. You can check the archives.

I am pretty certain the answer is that if the installation notes sais you must use Absoft then you can not substitute another compiler.

Anne April 14, 2005 17:18

Re: Fortran Compiler in Star-CD
 
I see, thanks a lot

sankar April 21, 2005 03:07

Re: Fortran Compiler in Star-CD
 
Hi,

I am using HPUX11 ant prostar v3.24 what fortran compiler I should use

sankar

steve April 21, 2005 14:52

Re: Fortran Compiler in Star-CD
 
If you are using HP-UX, you have to use HP's fortran compiler. You only need a fortran compiler if you want to write user subroutines for STAR. If not, you don't need one at all.


All times are GMT -4. The time now is 03:55.