 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2005, 07:33
|
Pro-am boundaries
|
#1 |
|
Guest
Posts: n/a
|
hi
I accidently put a wall where a boundary was needed, and don't know how to correct it. Could someone help? |
|
|
||
|
July 13, 2005, 01:08
|
Re: Pro-am boundaries
|
#2 |
|
Guest
Posts: n/a
|
Change the wall to required bounary type in "Define boundaires" panal.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF and boundaries | deneb | FLUENT | 1 | October 24, 2008 03:32 |
| Error: Boundaries too far apart | Lam | FLUENT | 0 | September 23, 2004 09:08 |
| boundaries | Peter | Siemens | 3 | June 17, 2004 16:14 |
| Help on Filter Boundaries | randz | Phoenics | 1 | November 19, 2002 19:44 |
| Particles at boundaries | Mark Farrall | CFX | 1 | April 11, 2000 10:02 |
Linear Mode
