CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   free surface outlet (http://www.cfd-online.com/Forums/cd-adapco/54939-free-surface-outlet.html)

novice October 17, 2005 01:55

free surface outlet
 
I am doing a free surface analysis. It is a manifold supplying coolant to the punch die assembly. Coolant is not fully filled in the manifold all the time (free surface). There are five outlets. I am not understanding what BC I should use for the outlets. Pressure or split outlet or any other. I do not know the flow split. So when I give atm pressure it diverges after 2 timesteps. If I use flow split outlet based on their area, run does not start at all, it comes out before starting. (some OS error)

Kindly help. Thanks in advance.

4xF October 19, 2005 05:59

Re: free surface outlet
 
Have you tried to use piezometric pressure with environmental option on?

Hope this helps....

novice October 19, 2005 07:31

Re: free surface outlet
 
Thanks 4xF. It is running with same pressure BCs now after reduction of pressure under relaxation factor.


All times are GMT -4. The time now is 06:44.