CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CD-adapco

Warnings

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   November 4, 2005, 14:07
Default Warnings
  #1
Dave
Guest
 
Posts: n/a
I have this warnings in run history

*** WARNING #038 *** UNNORMALISED RESIDUAL CANNOT BE REDUCED TO 1.000000E-06 IN EQ: PCOR ROUND-OFF ERROR RESCUE NOT ATTEMPTED; SOLUTION RETURNED WITHOUT UPDATE

*** WARNING #001 *** FLUID INFLOW DETECTED AT SOME OUTFLOW BOUNDARIES WHERE MASS FLUXES ARE FORCED TO ZERO.

F THIS CONDITION PERSISTS, YOUR RESULTS MIGHT BE WRONG THE OUTFLOW BOUNDARY MIGHT NOT BE WELL SPECIFIED OR THE GRID MIGHT BE TOO COARSE NEAR THE OUTFLOW BOUNDARY

** WARNING #090 *** VALUE ELOG*YPLUS OR ELOG*EFFVIS/(CAPPA*VISCOS) IS LESS THAN 1.1 AT 444 CELLS.UPLUS=YPLUS LAW IS USED. IF THIS SITUATION PERSISTS, INCORRECT RESULTS MAY BE OBTAINED.

Any help should be apreciated
  Reply With Quote

Old   November 9, 2005, 14:31
Default Re: Warnings
  #2
Jamie
Guest
 
Posts: n/a
error 038: the pcor unnormalised residual was below the residual tolerance on the first sweep

error 001: you have an outlet boundary in an area of recirulation and flow is trying to get back in. If you get it only a couple of times at the beginning of the analysis, you can ignore it. If you get it all the time that it must be dealt with. Either change it to a pressure boundary, which doesn't mind if flow goes in or out, or move the outlet farther downstrem.

error 090: your y+ values are too low for the turbulence model you are using and the near wall mesh is too fine. you could switch to a low Re model with the hybrid wall option on.
  Reply With Quote

Old   November 9, 2005, 22:08
Default Re: Warnings
  #3
JV
Guest
 
Posts: n/a
Thanks Jamie for your help. An additional doubt, when i change to pressure boundary at outlet, what is the difference in selecting: None, Zero Grad or TI/Lengh for the Turb. switch. My model is turbulent and i am using high reynolds ke with k/epsilon at inlet boundary.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
WARNINGS I don't want to have Gabriel CD-adapco 3 August 10, 2007 18:04
Not to display warnings? Yasser Nabavi FLUENT 3 June 4, 2006 09:27
Warnings and problems with bc evgenii OpenFOAM Pre-Processing 2 February 7, 2006 08:44
WARNINGS DB CD-adapco 0 January 19, 2006 14:47
lots of warnings Arnab CD-adapco 2 January 27, 2005 16:36


All times are GMT -4. The time now is 07:36.