CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > Siemens

Simulating from EVC to EVO in exhaust ducts

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   December 1, 2005, 07:20
Default Simulating from EVC to EVO in exhaust ducts
  #1
appino
Guest
 
Posts: n/a
Hello, I'm simulating the discharge run of an ICE (star CD vers 3.26). My troubles are in relation to the boundary condition to impose at the end of the exhaust duct. I use a calculated condition from a 1D simulation code (like Wave or GT-Power) defined at the same section that i have in the 3D model (end of the exhaust's primary pipe). The question regards if it's better to impose a Flow Mass condition (Inlet), Total Pressure or Static Pressure.

Thanks to everyone form your help.
  Reply With Quote

Old   January 8, 2006, 12:32
Default Re: Simulating from EVC to EVO in exhaust ducts
  #2
sachin
Guest
 
Posts: n/a
iam sachin from india tamilnadu i have developed the mesh for a single cylinder four stroke 5hp diesel engine that is the piston with two valves and ports. i know how to move the mesh of the piston but i cannot move both the inlet and exhaust valves .can u please help me to move the valves for 4 strokes reply bai
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Simulating nozzle exhaust in a free stream M. Mandour FLUENT 0 November 14, 2008 07:49
mixed convection and radiation through ducts vijay FLUENT 1 May 16, 2008 03:16
inclined ducts yousef Main CFD Forum 0 February 26, 2004 14:52
Heat transfer in ducts Peter Main CFD Forum 2 February 19, 2002 18:59
Rear facing NACA ducts abn Main CFD Forum 0 January 15, 2000 23:19


All times are GMT -4. The time now is 06:10.