CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CD-adapco (http://www.cfd-online.com/Forums/cd-adapco/)
-   -   compressor moving mesh (http://www.cfd-online.com/Forums/cd-adapco/55185-compressor-moving-mesh.html)

Bojan Stojanovic March 3, 2006 11:26

compressor moving mesh
 
I am trying to simulate radial compressor with compressible ideal gas in StarCD 3260.

Does anyone has any suggestions regarding turbulence model, time step, boundary conditions, initialisation values.....

My simulations are crashing due to negative densities.

I tried mass flow b.c. for inlet and pressure b.c. for outlet, but it keeps crashing. Also I tried pressure b.c. for inlet and nothing.

Target compressor speed is 140000 rpm.

I think that it is not a mesh problem, since my model works fine up to 90000 rpm.

I also tried restarting from pst file for 90000 rpm to increase the speed but always the same problem, negative density.

I would appreciate any suggestions.

Thanks in advance.

Bojan

Mac March 5, 2006 23:43

Re: compressor moving mesh
 
Hi,

May be that you need to reduce the time step size after 90000 rpm case. Since it happened to me once, I could solve the problem this way. Hope it works !!

Bojan Stojanovic March 6, 2006 03:24

Re: compressor moving mesh
 
Thanks, but I have already tried that. Even I tried with variable time step to keep Courant number below 2. I think I have to increase rotational speed gradually in order to avoid negative densities.

William Blake March 6, 2006 05:10

Re: compressor moving mesh
 
You should use the underrelaxation of the piso algorithm. (algo piso node 20 0.15 0.5) or lower. You can also try with "switch 60 on".


Bojan Stojanovic March 6, 2006 05:31

Re: compressor moving mesh
 
Thanks Blake, but I also tried using 0.5 for underrelaxation factor and it didn't help.

DU Run March 8, 2006 05:39

Re: compressor moving mesh
 
I think that the time step is too large. you should keep the Courant number below 1 or less.

Bojan Stojanovic March 9, 2006 04:48

Re: compressor moving mesh
 
I tried that also, even with variable time step to keep Courant number below 1, but simulation crashed. I have sent my model to adapco support and I can't wait to see results.

Thanks for help!!!!

xhliu1 March 15, 2006 02:37

Re: compressor moving mesh
 
Hi,Bojan Stojanovic!

When you get the method,I hope you can tell us. I have also come across the same problem.

Thanks!!



All times are GMT -4. The time now is 18:13.