piston motion
Hello Champs,
Help please. At the begining of compression stroke, while executing first event step, my mesh vertices of the BDC gethers on a edge of a cell and then after that event they moves properly to the TDC. While at the end of expantion stroke also they gethers at same position. I dont get any kind of errors while defining events or writing egrid file but my solution divergies and I am getting time steps for 205 degrees only in my .pstt file instead of 360 degrees. Bunch of thanks in advance. |
Re: piston motion
Hi,
I resolved it. |
All times are GMT -4. The time now is 05:19. |