projecting on shells
 

Hello, I want to project physical quantities on shells created by PSCREATE. The shells are not neat-looking in the sense there are a few which are too pointed or small. Is this a problem ? Due to the mesh geometry I have defined the planes with the command SNORM, vertex I,vertex II, vertex II and then used PSCREATE for the fluid cells around this section-plane. Thanks

Re: projecting on shells
 

There is no problem with the shapes. Depending on whether your starting data is cell-centered or smoothed (vertex data) the projection will either use each shell centroid or each vertex. There is no use of their shapes in the process.

Re: projecting on shells
 

To TG thank you very much.