 |
 |
 |
|
|
|
[Sponsors] | ||||
April 4, 2006, 10:29
|
error #008
|
#1 |
|
Guest
Posts: n/a
|
Hi,everyone.i am doing a spray model.but when i run ,there is a error ***parameter NDRMAX IS TOO SMALL. I adopt the order MEMORY NDRMAX 200/MEMORY WRITE to resize it, but there isn't the parameter in the built-in parameters. How should i solve it?Thanks for answering!
|
|
|
||
|
April 4, 2006, 13:49
|
Re: error #008
|
#2 |
|
Guest
Posts: n/a
|
If you have this error while running STAR-CD solver, then you can edit parm.inc file before running the solver.
|
|
|
|
||
|
April 7, 2006, 05:45
|
Re: error #008
|
#3 |
|
Guest
Posts: n/a
|
to John Luo:
I modified the parameter 'NDRMAX' in the file of parm.inc.The key problem is that the value of the parameter "NDRMAX' is always equal to the value of Maximum Number of Parcels i had set on the panel of Droplet Controls.That is to say it is invalid if i directly modify it in the file of parm.inc.It will report one error again when i run the solver. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| strange fluent error: Primitive Error at Node 0 | Jean-Baptiste | FLUENT | 8 | June 14, 2022 11:11 |
| error in COMSOL:'ERROR:6164 Duplicate Variable' | bhushas | COMSOL | 1 | May 30, 2008 04:35 |
| "Error: Floating point error: invalid number" | MI Kim | FLUENT | 2 | January 4, 2007 10:00 |
| Fatal error error writing to tmp No space left on device | maka | OpenFOAM Installation | 2 | April 3, 2006 08:48 |
| Error: Floating point error: invalid number | Bob | FLUENT | 3 | June 3, 2005 18:11 |
Linear Mode
