Dear all, i am a begginer using starcd 3.22:

I want to mesh a truncated cone in star 3.22, how could i do it, the bottom ratio is 148.95 mm, upper ratio:124.4 mm, height:210 mm.

Thank you in advance for your help

hi,

examples are given in users manual...its rather easy just go through it you can use block meshing for your geometry...no need of automesh

Hi:

Sorry, i am beginning with Starcd, but, are there any example on the user manual about this geometry?, or what command could i use.

Thanks

[liya]

Hi, I am a begginer at CFD, please help anyone with my mesh. I defined 2 radial edges in a laminar pipe (# of devisions 30) and 2 top and bottom edges of the same pipe (# of devisions 100). under mesh/statistics shows 3000 elements, where i should get 6120 by the stated problem. what did i miss? Also, i cannot plot XYplot, gives me error: no data points in range, what does it mean? thanks.

[hwangkl]

Originally Posted by Jorge
;171337

Dear all, i am a begginer using starcd 3.22:

I want to mesh a truncated cone in star 3.22, how could i do it, the bottom ratio is 148.95 mm, upper ratio:124.4 mm, height:210 mm.

Thank you in advance for your help

echo off
csys,2
vc3d,0,148.95,10,0,360,36,0,210,1
vset, all
vmerg,vset,,0.0001,,,,,,,low,delete
c
cset,all
vset, news, edge
vset subs gran ,,,,,200
vmod vset 124.4 f f
vset add gran ,,,,,,200
vsmo 1 1000
crefine,1,1 ,10,cset,0,0,merg,nocouple
cset,all
cplo