|
[Sponsors] |
May 10, 2006, 05:05 |
In what condition need the tran.dat file
|
#1 |
Guest
Posts: n/a
|
I am working on c12h26 autoignition. when solving, the tran.dat is required. but when I copy the file into the working folder, it is told that SPECIES C12H26 CAN NOT BE FOUND IN tran.dat. so what can I do to make the solution need not the tran.dat file? Thanks a million.
|
|
May 10, 2006, 09:17 |
Re: In what condition need the tran.dat file
|
#2 |
Guest
Posts: n/a
|
tran.dat is used when chemkin module has been run, you should check the tran.dat file to confirm that c12h26 is inclued in the file.
|
|
May 11, 2006, 07:04 |
Re: In what condition need the tran.dat file
|
#3 |
Guest
Posts: n/a
|
what combustion model using?
|
|
May 15, 2006, 10:44 |
Re: In what condition need the tran.dat file
|
#4 |
Guest
Posts: n/a
|
none
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mapping a boundary condition from file | alberto | OpenFOAM Running, Solving & CFD | 19 | January 28, 2022 08:02 |
Too low Flame temp for Spe.Tran. Produce Gas Comb | Manoj Prasad | FLUENT | 4 | November 22, 2005 01:09 |
set boundary condition in Neutral file, in Gambit | Vito Chow | FLUENT | 2 | April 26, 2005 06:50 |
tran.dat | cmv | Siemens | 1 | February 26, 2005 15:37 |
heat tran simulation two phase closed thermosyphon | mohammad reza | CFX | 1 | February 28, 2004 00:48 |